The European Commission set binding rules for how EU countries prove and subtract road dust from winter sanding and salting in PM10 pollution figures.
The European Commission has set common rules for how EU countries can discount road dust from winter sanding and salting when checking air quality. The rules take effect on the twentieth day after their 6 November 2026 publication.
Commission Implementing Decision (EU) 2026/2468 was adopted on 5 November 2026 and published in the EU’s Official Journal on 6 November 20261. It applies to EU member states and the authorities that measure and report their air quality. Countries that want to subtract road dust from their pollution figures must now prove it in technical reports sent to the Commission1.
| At a glance | Details |
|---|---|
| What was published | Final implementing decision (binding technical rules) |
| Published on | 6 November 2026 |
| Who must comply | EU member states seeking to discount road dust from sanding or salting |
| Effective date | Twentieth day after publication in the Official Journal |
| Next milestone | Member states submit technical reports to the Commission |
What is road dust, and why does it matter?
In winter, road crews spread sand or salt to stop cars from skidding. Traffic and wind later lift that material back into the air as fine dust1. This dust counts toward PM10, the measure of airborne particles 10 micrometres or smaller.
The decision rests on Directive (EU) 2024/2881, the EU’s recast law on ambient air quality and cleaner air for Europe, adopted on 23 October 20242. That directive sets air quality standards and rules for monitoring and reporting1. It also lets countries subtract road dust from sanding or salting when they check whether PM10 limits were broken1.
The directive takes account of updated World Health Organization (WHO) guidelines on particle pollution2. The Commission must carry out its first review of the standards by 31 December 20302.
What the Commission’s new rules require
Subtracting road dust can let a country avoid drawing up an air quality plan for an affected zone1. But it must have taken reasonable steps to lower the pollution1. The decision sets five principles that every claim must meet1.
| Principle | What member states must show |
|---|---|
| Clear cause | The excess pollution clearly came from sanding or salting |
| Precise numbers | The dust share is measured accurately for the right time period |
| Right location | The monitoring site represents the area affected |
| Action taken | Reasonable measures were used to cut the dust |
| Method explained | Enough detail on the method used |
The decision also notes that subtracting the dust must not stop countries from acting to reduce its health impact1.
How countries must identify dusty days
Countries must first pick out the days when sanding or salting may have played a role1. For sanding, at least one application must have happened earlier in the winter. There must also be evidence that sand was still on the road1.
For salting, countries must consider when salt was last spread. They must also weigh temperature, rain and road surface conditions since then1. In both cases they must check how close the monitor sits to treated roads and whether the road was dry1.
Countries must also rule out other sources. They must show that no other source contributed significantly to the high readings1.
How the dust share is measured in practice
Countries may use any suitable method that meets the precision principle1. Where data for other methods is missing, they may use the coarse PM fraction method. This method treats 50% of coarse particles as coming from sanding1.
| Method | Conditions set by the decision |
|---|---|
| Coarse PM fraction (sanding) | Ratio of fine to total particles (PM2.5/PM10) at or below 0.5 |
| Coarse PM fraction (sanding) | Studded tyres not used or no more than 1% of tyres |
| Chemical analysis (salting) | Chemical makeup of the salt used must be known |
| Chemical analysis (salting) | PM10 samples collected and analysed for each affected day |
Results must be worked out for each monitoring site and each day, in micrograms per cubic metre1. If a country cannot show the adjusted reading is below the daily limit, the excess still counts1.
For the annual limit, countries must use the adjusted daily figures. They may not simply drop the high days from their statistics1.
Reports and evidence for the Commission
Countries must send the Commission evidence of steps taken to cut the dust1. Examples in the decision include street cleaning, snow removal and dust binding, which means treating roads so dust sticks to them1. Better sanding and salting practices and road maintenance also count1.
Both this evidence and the method used must be filed as technical reports1. An annex lists what each report must contain, such as the reported year, the responsible authority and the affected zones1. A Commission technical support document from November 2026 reflects current best practice among member states1.
Key terms in plain words
| Term | Meaning |
|---|---|
| PM10 | Airborne particles 10 micrometres or smaller |
| PM2.5 | Finer particles 2.5 micrometres or smaller |
| Coarse PM | The difference between PM10 and PM2.5 readings |
| Re-suspended particles | Dust on roads that traffic or wind lifts back into the air |
| Implementing decision | A binding Commission act that sets technical details of an EU law |
| Air quality plan | A plan a country must draw up when pollution limits are broken |
The decision enters into force on the twentieth day after its 6 November 2026 publication in the Official Journal1.
Sources
- ↩ Implementing decision – EU – 2026/2468 – EN – EUR-Lex https://eur-lex.europa.eu/eli/dec_impl/2026/2468/oj/eng
- ↩ Directive – EU – 2024/2881 – EN – EUR-Lex https://eur-lex.europa.eu/eli/dir/2024/2881/oj/eng