MSHA proposed revising its 2024 mine silica dust rules, adding a 21% testing error allowance. Comments are due Jan. 11, 2027.
The US Mine Safety and Health Administration (MSHA) has proposed changes to its 2024 silica dust rules for miners. Comments are due by midnight Eastern Time on Jan. 11, 2027, with a virtual public hearing on Dec. 15, 2026.
MSHA, the Labor Department agency that sets health and safety rules for mines, published the proposal in the Federal Register on Nov. 12, 20261. It revises rules on how mines control, measure and record exposure to silica dust, and on respirators and medical checks2. The exposure limits stay the same, and MSHA will weigh comments before writing final rules2.
| At a glance | Details |
|---|---|
| What was published | Proposed rule changing the 2024 silica and respirator rules for mines |
| Published on | 12 November 2026 |
| Who can comment / Who must comply | Any member of the public; coal and metal and nonmetal mine operators would comply |
| Feedback deadline / Effective date | 11 January 2027 (comments) |
| Final rules / Next milestone | Virtual public hearing on 15 December 2026 |
What is silica dust, and why does it matter?
Respirable crystalline silica is fine mineral dust that miners can breathe in. The Mine Safety and Health Act of 1977 requires standards so that no miner suffers serious harm to health over a working life2.
The Labor Department’s Office of Inspector General (OIG), its internal watchdog, reported in November 2020 that MSHA’s silica limit was out of date3. That put miners at risk of life-threatening health problems, the watchdog said3.
How the 2024 rule got stuck
MSHA published its final silica rule on April 18, 20242. It set the exposure limit at 50 micrograms per cubic meter of air, averaged over an 8-hour shift2. The rule took effect on June 17, 20242.
Coal mine operators were due to comply by April 14, 2025. Metal and nonmetal mines, such as stone, sand and gravel pits, had until April 8, 20262. Industry groups, including the National Stone, Sand and Gravel Association, challenged the rule in a federal appeals court2.
On April 11, 2025, the Eighth Circuit Court of Appeals paused the rule’s compliance deadlines while it reviews the case2. MSHA has paused enforcement in line with that order2. The OIG warned the delay could leave miners exposed to higher dust levels3.
| Key date | What happens |
|---|---|
| April 18, 2024 | MSHA publishes the final silica rule |
| June 17, 2024 | The 2024 rule takes effect |
| April 11, 2025 | Appeals court pauses compliance deadlines |
| Nov. 12, 2026 | MSHA publishes the proposed changes |
| Dec. 15, 2026 | Virtual public hearing |
| Jan. 11, 2027 | Comment deadline |
What the proposal changes on dust testing
After the 2024 rule, MSHA held seven stakeholder meetings and fielded many questions2. A common question was how MSHA would cite mines for test results above the limit2.
MSHA found its own inspectors’ samples were consistent. Operators’ samples varied more, because operators use different samplers, labs and test methods2. The proposal adds a single 21% error factor, an allowance for normal measurement error2.
That allowance would apply to both MSHA’s and operators’ test results2. Only MSHA’s own samples would be used to cite a mine for breaking the limit2. Operators would use their results to decide when to act to protect miners2.
What changes for respirators and medical checks
MSHA proposes to clarify when metal and nonmetal mine operators may use respirators2. It would also adopt the respirator standard of the Occupational Safety and Health Administration (OSHA)2. MSHA says this would make miners safer when they wear respirators voluntarily2.
Medical checks would become more risk-based, focusing on miners at risk of harm from too much silica2. MSHA cites possible shortages of B Readers, specialists certified to classify chest X-rays for these exams2. It also expects growth in mines for critical minerals2.
Metal and nonmetal miners would get easier access to voluntary medical exams2. Operators would no longer have to make sure chest X-ray results are sent to the National Institute for Occupational Safety and Health (NIOSH)2.
What stays the same
The proposal keeps the 50 micrograms per cubic meter exposure limit for all miners2. It also keeps the action level of 25 micrograms, the point where extra steps begin2.
| Measure | Proposed status |
|---|---|
| Exposure limit | 50 micrograms per cubic meter, unchanged |
| Action level | 25 micrograms per cubic meter, unchanged |
| Error allowance | New 21% for MSHA and operator samples |
| Who can trigger a citation | MSHA samples only |
| Respirator standard | Adopts OSHA’s standard |
The proposal also updates recordkeeping and makes matching changes to other mine safety rules2. It rewrites the rule on rotating miners between jobs to keep exposure under the limit2.
How to take part in the rulemaking
Comments must cite RIN 1219-AC22 or Docket No. MSHA-2026-02002. They can go through the federal online rulemaking portal, by email, or by mail2. MSHA will post comments publicly without changes2.
The virtual hearing starts at 9 a.m. Eastern Time on Dec. 15, 2026, and may continue on Dec. 162. Speakers who register in advance will be called first2.
Key terms in plain words
| Term | Meaning |
|---|---|
| Respirable crystalline silica | Fine mineral dust that miners can breathe in |
| Exposure limit | The most dust a miner may breathe, averaged over an 8-hour shift |
| Action level | A lower dust level that triggers extra testing and steps |
| Error factor | An allowance for normal variation in test results |
| B Reader | A NIOSH-certified specialist who classifies chest X-rays |
| Metal and nonmetal mines | Mines other than coal, such as stone, sand and gravel |
Comments on the proposal are due by midnight Eastern Time on Jan. 11, 20272.
Sources
- ↩ Federal Register :: Respirable Crystalline Silica and Respiratory Protection https://www.federalregister.gov/documents/2026/11/12/2026-23048/respirable-crystalline-silica-and-respiratory-protection
- ↩ Federal Register, Volume 91 Issue 217 (Thursday, November 12, 2026) https://www.govinfo.gov/content/pkg/FR-2026-11-12/html/2026-23048.htm
- ↩ CBJ-2027-V3-04.pdf https://www.dol.gov/sites/dolgov/files/general/budget/2027/CBJ-2027-V3-04.pdf